Archive for the ‘factory stereo’ tag
Car Audio Tips for Maximum Bass In A Vehicle Audio System
The purpose of a subwoofer is to add some bass to the audio that is played in the stereo. An already existing factory stereo can be made to play powerful music by adding subwoofer to it. By following these guidelines on how to install a subwoofer in a factory stereo, the installation can be done with little or no help from a professional.
To do the installation of the subwoofer, a wiring kit for amplifier, harness adapter, screwdriver, tool for the removal of the panel, drill, wires, wrench and grommets made of rubber.
The battery of the car is disconnected till the installation is done. The negative terminal cable is removed from the terminal. A screwdriver or an appropriate wrench can be used to loosen it. A ring terminal is attached between the power cable and positive terminal of the battery. The cable for power supply is routed between the compartment where engine is kept and the vehicle’s inner cabin. There is generally an aperture for the wire but if there is no such facility a hole can be drilled and use a grommet for protection.
Before getting into the job first the amplifier kit should be run. It is made to run by connecting it to the battery’ s positive terminal. This step is done easily. They can be made to run through the carpet , by the side of seats and then to the car trunk. This is the power wire. Another wire called remote wire also should be connected to the car trunk. Run it in the same manner as the [power wire and reach the car trunk. The fuse of car lighter or even the car stereo can be used for this connection because as we turn on the car key the amplifier gets switched on.
The connector should always be in contact with the metal portion of the wire so it is sent in to make proper connections. Only the wire for insulation can be allowed to expose out.
The connector is placed in the tool and it is squeezed hard. This is done to make the colour of the crimping tool and the electrical wire same. To ensure a good connection one can choose to do it with a lengthy wire where one can do this kind of work at various places. It is all dependent on the length.
After all connections are made its time to enjoy the sound. People who are deeply passionate about music and powerful sound should make a check of local noise laws for permitted sound level. Another useful tip may be don’t make an attempt to play such loud music before police to show off our new sub woofer installation as we may end up paying fine.
The above were some guidelines on how to install a subwoofer in a factory stereo. The quality of the audio can be improvised by adding a powered or non-powered sub. The above was a discussion of connecting a powered sub. A non powered one can be connected only if the stereo has an amplifier built in the stereo.
Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.
Mail this postPopularity: 1% [?]